New Edge Patriot 338 Magazine Type Bar Feed

General Specifications per Manufacturer

Bar Capacity:
No Prep: 3mm to 33.2mm (.118" to 1.312")
With Prep: 3mm to 38 mm (.118" to 1.500")
Maximum Bar Length: 12'6"
Minimum Bar Length: 39.4"
Maximum Remnant Length: 16"
Magazine Rack Capacity: 12"
Bar Loading Cycle: 30 seconds for 12' bar
Material Straightness Specifications: .007"TIR/ft of material
(V Blocks, 3 points equidistant)
Feed Force (pusher torque): max 450N, adjustable
Foward Feed Rate: 750 inches/min max, adjustable
Return Feed Rate: 1000 inches/min max, adjustable
Power Consumption: 1.5kW
Operating Voltage: 230V/60 Hz - 3 phase
Control Voltage: 24V DC
Oil Capacity: 57 liters (15 gallons)
Oil Viscosity: ISO 100cST
Compressed Air Supply: 6 bar (90 psi)
Compressed Air Consumption: approx. 8 liters per loading cycle
Weight (approx): 2,100 lbs
Dimensions (approx.): 16' x 2' x 4.25'

Includes:
(1) Guide channel set matched to the lathes capacity
(1) Telescopic nose to match guide channel set
(1) Barstock collet
(1) Outboard anti-vibration device bushing block set
(1) Swiss style synchronization and lathe adaption kit
(1) Custom lathe cable & interface plug

Edge Patriot 338/12' 2 Guide Channel Set Complete Package
Includes (2) Channel Sets, (2) Pushers, (2) Telescopic Noses, (2) Pusher
Collets & (2) Sets of Bushing Blocks: $37,900.00

Edge Patriot 338/8': $32,400.00

Edge Patriot 338 8' 2 Guide Channel Set Complete Package
Includes (2) Channel Sets, (2) Pushers, (2) Telescopic Noses, (2) Pusher
Collets & (2) Sets of Bushing Blocks: $35,900.00

Optional Accessories - Prices subject to change without notice:
Installation USA: $3450.00

Additional Guide Channel Set: $ 3750.00
(includes pusher, revolving tip, nose liner & spindle liner (suggested for
10mm and below)

Spindle Liner: $580.00 each
(needed when selecting a guide channel set other than the lathes max. cap)

Bar Stock Pusher Collets (specific collet required for each bar diameter):
For bar stock OD's up to 38MM $185.00 each

Bushing Blocks for outboard Anti-Vibration device:
(1) set includes upper & lower pieces: $175.00 each

Moveable Anti-Vibration Bushing Blocks Required for Profiled Material
(8mm - 20mm - 30mm): $245.00

Dual channel Safety kit $500.00

CSA kit (Canadian Standard Association) $1000.00

High Voltage Kit (Required for some lathes):$ 750.00

Serial interface Ethernet connection $1800.00

Axial Shift Device w/ Safety Switches $2000.00

Long Pusher Kit $2600.00

Tall Stands $2500.00
for lathes with Spindle center >1250mm

Master liner $ 650
required when undersizing barfeeder to lathe spindle (still requires spindle liner)

Bar Feeder installation does not include lathe-side software or hardware
interface. This interface must be supplied and installed by the lathe
OEM or dealer prior to bar feeder installation.

The anchoring of the FMB bar feeder to the floor is a requirement and will be
performed by the service technician.