Crest F-200 20x16 Twin Sump Immersion Solvent Cleaning System, New in 2005

To the best of our knowledge all details listed below are deemed correct.
It is the buyer’s responsibility to confirm all details and we encourage an inspection of the machine(s) and accessories prior to purchase.

General Specifications:
This unit is a Self-Contained 2-tank 5-zone Ultrasonic Cleaning System
Process Sequence
Stage 1 – Load
Stage 2 – Vapor Wash
Stage 3 – Immersion Wash
Step 4 – Vapor Wash
Step 5 – Flash Dry
Step 6 - Unload

The F200-2016 is a Twin Sump Immersion Solvent Cleaning System to incorporate
the technical capability of running Non flammable Solvent, via simple temperature
adjustment. The twin sump consists of vapor boiling sump and rinse sump. The
boiling sump is built-in with 9KW immersion heaters with Electronic Vapor Control
System via PLC control with operator interface touch-Screen. The rinse sump comes
with 1500W 132Khz ultrasonic and a recirculation pump with filtration loop.

The system has 2 condensing units, for freeboard and primary cooling coil with four
sided condensing coils. The temperature controller of the compressor provide fine adjustment on defrost mode setting to prevent ice formation on the freeboard cooling
coil, All these are controlled by PLC. The system is designed with 120% freeboard
area. Two safety thermostats are built-in for high solvent temperature cut off and
high vapor temperature cut off besides low liquid cut off.

All Service Points, Drain, Electronic etc can be found under the front cover that is
easily removable. The facility requirement for the system is 208V, 3 phase, 60Hz
66Amps.

The system is controlled by PLC with operator interface touch-screen. It consists of
3 different modes of operation:
•Cool Down mode
•Cleaning mode
•Maintenance mode

The system tank is fabricated from high grade, bright-annealed stainless steel with
double-sided welding and polishing for added durability and minimum
contamination entrapment. The tank is housed inside a stainless steel grade 304
framework.
The tank is positioned towards the front portion of the frame for easy accessibility
and operation. An electrical enclosure is mounted at the side of the machine. All
other system components are compactly housed behind the tank but still inside the
frame and covered with panels.