Buy Machinery Sell Your Machine Used Machines Auctions & Appraisals Appraisals New Machines Machine Videos Financing Blog & News Contact Who We Are
FACEBOOKLINKEDINYOUTUBEEBAY
(303) 651 - 6545
Used Machines
BAR CHAMP 108JB3
Model:
108JB3
Stock #:
400840
Manufacturer:
BAR CHAMP
(New) BAR CHAMP #108-JB-3 AUTOMATIC BAR CHAMFERING MACHINE
General Specifications As Per Brochure

Bar Capacity:
Round: 1/2" - 4-1/4"
Hex: 3-3/4"
Square: 3"
Bar Height: 41"
HP: 3
RPM: 360
Min. Part Length: 18"
Mach. Width: 41"
Mach. Length: 40"
Weight (Approx): 530 lbs
Equipped with (must be verified by buyer):
30 degree Chamfer tool standard w/3/4" square 8 sided carbide insert
3-jaw chuck. Chuck & bar remain stationary, the cutter revolves around
the bar.
Single speed positive drive gear box (no blets to slip or adjust)
230/460 volt, 3 phase, 60hz motor & switch
Adjustable bar & slide stops for consistent chamfering
Ball bearing ways
Removable chip pan
Bar support stand
Optional Equipment

** Prices subject to change without notice ***

Air Operated Chucking (Actuators, Valves, & Brackets Included) $1,695.00
Variable Speed (AC Inverter with 3 HP Motor) (58 - 700 R.P.M.)
For deep chamfers on hard or difficult to machine materials ...$1,450.00
Mist Spray Coolant System (May be recommended for deep chamfers on
difficult to machine materials) ...............................$ 445.00
Cutting Oil Drip System+
(For deep chamfers on difficult to machine materials) .........$ 695.00
Square Stock Adapter (Up To 2") (One Needed For Each Dia) .... $ 325.00
Castors .......................................................$ 895.00
Additional Bar Support Stand, 2,000 Lb. Capacity ..............$ 235.00

Turn and Chamfer Toolholder (#5279) with Inserts
(Fits in Standard Cutterhead)................................ $ 425.00
-Replacement Inserts (TPMT 3252MF) .....................(each) $ 29.00
Additional 30-Degree Chamfer Toolholder (#5069)
with 3/4" Carbide Insert .....................................$ 345.00
-Replacement 3/4" insert for #5069 Toolholder (SNMP-643) ......$ 27.00
-Replacement Insert Screw for #5069 Toolholder (0530641) ......$ 16.50
Tube Head Assembly (For simultaneous ID & OD Deburring and Facing
of Tubing) This Clamps Into the standard 300-1 series cutterhead
(ID, OD, and Facing Cartridges & Inserts included) ............$ 975.00
Special Toolholders (Alternate degree chamfer, Special length Turn and
Chamfer, Chamfer and Face, etc.) .............................. Quoted
Heat Treated crate for Int'l Shipments ........................$ 625.00